All About Limo Journal News

Easy Tips To Cure Your Plumbing Woes

Mar 16

 

You need to have some knowledge of what to look for and expect from doing your own plumbing. You need to know what resources are available to you and who can provide you answers as to what you need for your future plumbing jobs. The tips below can help you with how to start.

Plumbing Giant

You can prevent frozen pipes within the home, by ensuring the temperature does not fall below freezing. Another important step is insulating pipes that are exposed to cold temperatures. Your plumbing can freeze if the air around it is below 32 degrees. It may take time to thaw so that you can have running water. On the other hand, they can burst, which gets messy and really expensive.

Be careful about using liquid clog cleaners. These liquids can contain chemicals that are extremely bad for your pipes. Instead, use a snake or a plunger to dislodge any clogs you might encounter. Be sure to try these things before giving up and calling a plumber, who will probably re-perform those same acts.

If you have a clogged drain, don't use cleaning chemicals to try to clear the clog. These harsh chemicals can corrode your metal pipes leading to leaks and broken pipes over time. Instead, stick to a plunger or make use of a plumbing snake to clear them.

Find a better way to discard of cooking oil instead of pouring it down the drain where it can easily clog your pipes. Keep a coffee can or other metal container handy to pour grease into after cooking. Place the can in the freezer to harden the grease and when it's full, discard it with the trash.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

Some people have problems with their plumbing system in that the pipes sweat and drip condensation. You do not have to hire a plumber to take care of this nuisance. You can purchase self-adhesive drip tape from your local hardware store. This drip tape will insulate your "sweating" pipes which are dripping with moisture built up from condensation. To make sure the tape sticks firmly, dry the pipe thoroughly before applying the tape.

To avoid sediment buildup, drain gallons of water from your water heater to flush any corrosion. This will help your heater to run more efficiently therefore saving you regular energy costs. Make sure to read your heater's instructions before attempting this, and do this periodically to make sure that your heater is running as well as it can.

If you have problems with a slow drain, there are easier things you can do other than removing the pipes to clean it. There are certain tools made just for this purpose that you insert into the drain to loosen the clog so it washes away or grab it and remove it completely.

A good tip to use when using your garbage disposal is to leave the water turned off. Most plumbers advise that you run water when using your garbage disposal, although many disagree. In point of fact, sending water and garbage through the disposal together can shorten its lifespan by encouraging more waste to stick to the moving parts.

To avoid freezing pipes in the winter, make sure to insulate any exposed pipes in you basement before winter comes. Pay extra attention to pipes near the outside walls. If you have had a problem with any particular pipe freezing in the past, apply some heat tape to insulate those pipes.

To prevent pipe banging when you turn on the water, think about rubber blankets or straps. Instead of assuming the pipes need replaced, consider anchoring them or buffering them. If your pipes are plastic, leave them some room for expansion and contraction. If pipes do not leak but just make noise, eliminate the noise.

Have a specific plumber in mind before you have an emergency. Most people don't think about plumbers until they find themselves having a big problem that needs to be fixed right away. Instead, choose a plumber who you are comfortable with and whose experience you trust--way before you actually need his services.

As you have seen in the above tips, there is a lot of knowledge you can acquire before starting to do your own plumbing and it's this knowledge that can help you with your future plumbing jobs. Do everything you must to find out what you need to get started.

Plumbing Giant